Straight Mount Plumbizer
Assembly: 35E
The 35E plumbizer is designed for signal head mounting mid-mast arm, end of mast arm, or on the pole. It uses a ball and socket mounting point for easy leveling adjustment to ensure your signals are plumb and level. Mounting the signal heads is easy with just a washer and locking nut. The plumbizer is bolted tightly and does not use set screws for adjustment making it almost maintenance free. Pedestrian signal heads can also be mounted to the 35E which will allow the traffic signals and pedestrian heads to be aligned with each other on the pole while maintaining the ability to aim the signals in the appropriate directions.
-
Ball-in-socket design for easy signal aiming
-
Bolted design for little to no maintenance
-
Can be mounted anywhere with accompanying adaptor
-
Buy America, Build America (BABA) Compliant
Applications
Clean-Looking Signal Mounting
01
Overhead Traffic Signal Mounting
This plumbizer is designed to mount signals overhead on the mast arm. Whether you have an existing hub or need to use a strap adapter to relocate the signal after an intersection upgrade, this signal mount is ready to ensure optimal visibility for motorists and pedestrians.
03
Multiple Signal Heads
One plumbizer for all signal head arrangements. The load on this plumbizer allows for a wide range of signal arrangements. From a single pedestrian signal head or a six stacked signal arrangement, this plumbizer has been designed to meet your signal mounting specifications.
02
Vertical Pole Mounting
If you need to mount a signal head arrangement in any location, this plumbizer is very adaptable. This plumbizer was designed to mount on any surface - including walls and other flat surfaces. If you have a stand-alone signal arrangement, this is a reliable option.
04
Low Maintenance Locations
We have designed our plumbizers to bolt to a flange. This means there is virtually no maintenance after the initial install. Many other plumbizers rely on clamping set-screws which will loosen over time. Our plumbizer is designed to stand the life of the intersection.
Third Party Load Tested
We want to ensure the installers have a reliable baseline to load each arrangement. We have load tested the 35E at third party labs to have an unbiased review of its load capacity. This plumbizer is rated for approximately 1,500 pounds of load prior to failure. This ensures that if the traffic signal is struck by a vehicle, the plumbizer will break prior to twisting the mast arm - resulting in a low cost and quick reinstallation of the incident.
Load testing results in reliability for the installer, and safety for the motorists and pedestrians.
Installation Instructions
